Need a custom length driveshaft, than this is the solution. This kit comes with everything you need to replace your factory u-joint style driveshaft. Our driveshaft's are made to order. If your driveshaft length is an in between size pick the next size larger. If a custom size you need isn't here be sure to give us a call.
Kit includes: New complete double cardan C.V. driveshaft with 1310 size u-joints (custom lengths available)
How do I get the right driveshaft?
Kit includes: New complete double cardan C.V. driveshaft with 1310 size u-joints (custom lengths available)
How do I get the right driveshaft?
- Plan ahead. Because a SYE typically needs a custom driveshaft, think about another mode of transportation while your custom shaft is being built and shipped to you.
- Install your suspension lift first.
- Install your slip yoke eliminator next.
- Make pinion angle adjustments until you are close to proper geometry for CV driveshaft.
- Measure from center of u-joint at the transfer case yoke to center of u-joint at the pinion yoke. The following illustration shows the arrows
pointing to the flat mounting surface on each yoke from where it's easiest to measure:
- Call IRO (or your preferred driveshaft supplier) with the length you measured accurate to within 1/8" inch.
- Double cardan driveshafts can be purchased at many different retailers. Iron Rock Off Road does fulfill custom driveshaft orders all the time and the typical turn-around time is NEXT DAY!
IMPORTANT NOTE:
- Larger size u-joints available upon request but will change the cost of the shaft. Please call IRO to inquire.
- No returns on custom length driveshafts.