A ball-in-socket type flex joint is the solution that lasts and takes the stress off your track bar mount. These Flex Joints have held up extremely well in the market and have solved every problematic bushing application we have encountered. They are extremely rigid while still allowing the necessary misalignment. You can be certain they will solve any track bar bushing related issues you have.
Eight grade 9 (170,000 psi) bolts hold this joint securely in place within your track bar. Our testing shows that this small joint can withstand HIGHER side loads than even some competitors large flex joint!! No special tools or skill is required to install these either! Anyone can do it right in their driveway.
We offer different sizes for the different track bars we manufacture.
WIDE BODY:
- Outside Diameter: 2" (fits in existing IRO XJ/ZJ/TJ/WJ track bar)
- Width: 1.64"
- Bolt Size: 12mm to fit XJ/TJ/ZJ/WJ or 14mm to fit JL/JT/JK
- Race Material: Delrin
- Misalignment: +/- 13 degrees
- Lubrication: Maintenance free (grease them once during installation)
- Can be used on the axle side of an XJ/ZJ/TJ by drilling out the axle bracket hole and installing a 12mm bolt and nut. Will also fit competitor track bars with an inside diameter of 1.510, a width of 1.250, and radiused or chamfered inside corners (can be chamfered manually during installation). Allen wrench included for installation.
NARROW BODY:
- Outside Diameter: 2"
- Width: 1.64"
- Bolt Size: 14mm To fit JL/JT
- Race Material: Delrin
- Misalignment: +/- 13 degrees
- Lubrication: Maintenance free (grease them once during installation)
- To be used with male end 77128